User's Manual

HID CORPORATION

PROGRAMMING CARD ONLY USE

To program Card ONLY use with Command 50, simply omit

the keypad PIN values from the sequence:

1. Place the EntryProx unit in program mode. Press:

99 # Master Code * (default is 1234)

2. On the EntryProx keypad, press:

50 # user-type # user location # **

3. Press * to exit program mode.

PROGRAMMING CODE

OR CARD

To program a user for either Code OR Card:

1. Place the EntryProx unit in program mode. Press:

99 # Master Code * (default is 1234)

2. On the EntryProx keypad, press:

52 # user-type # user location # keypad PIN

* keypad PIN * <present card>

3. Press * to exit program mode.

BATCH LOAD CARDS BY KEYPAD ENTRY

Command 56 allows you to batch load multiple, sequential

26-bit HID cards into the EntryProx unit. Up to 1,999 users

can be added at one time. Cards need not be presented to the

reader. Requirements are:

• Cards must all have the same facility code.

• Cards must be sequentially numbered

• The facility code must be programmed into

the unit before any batch loading. See Table

2, Command 32 for the procedure. (This

facility code cannot be changed at a later

time).

Cards with multiple facility codes or many numbering gaps

must be entered by presentation to the reader, using

Command 53.

USER TYPES - REMINDER

0-Toggle 1-Normal 2-Dump 3-Lockout