User's Manual

HID CORPORATION

WIRING THE REQUEST TO EXIT INPUT

When the EntryProx Request to Exit (REX) input receives a

momentary switch closure, it engages the main relay for the

programmed access time. It can be connected to a wall-

mounted exit button, to a push button under a reception

desk, or to the relay output of a passive infrared motion

detector mounted above the door on the secure side. The

Request to Exit input activates the alarm shunt to prevent

false alarms when personnel use the controlled door to exit

the secured area. The Transaction Log records all Request to

Exit usages for monitoring purposes.

To wire the EntryProx Request to Exit input, refer to Figures

16 and 17.

Locate connector P2 on the main circuit board and remove

the 2-pin jumper installed on pins 5 and 6.

Refer to Figure 17 to make the wiring connections to the

cable assembly if you are NOT using a door contact

Note: If you do not use a door contact, you need to twist the

white and orange wires together or the REX input will not

function.

Note: The door contact

must

be closed for the Request to

Exit feature to work properly