User's Manual

ENTRYPROX – 4045-907 REV A

MOUNTING AND WIRING THE ANTENNA HOUSING

FOR A SECURE INSTALLATION

Mount and wire the antenna housing no more than 10 feet

away from the controller keypad unit.

To mount and wire the antenna housing, refer to Figures 7

and 8 and follow these instructions.

1. Pull the additional antenna cable through the

antenna housing’s backplate cable holes.

FIGURE 7: MOUNTING THE ANTENNA BACKPLATE

2. Position and secure the antenna backplate to the

mounting surface so that the two moisture release

holes are on the bottom.

3. Cut the plastic connector off the antenna cable

assembly.

4. Splice in the additional antenna cable. Be careful to

match the wire colors to the proper pin connectors

on the 10-inch antenna cable assembly.

5. Attach the antenna housing to the backplate by

inserting the four securing tabs into the backplate.

6. Seal the wire holes with silicone.

Cable Holes

Moisture Release

Holes