User's Manual

HID CORPORATION
9
FIGURE 4: REMOVING THE CIRCUIT BOARD
WIRING THE CONTROLLER KEYPAD FOR A SECURE
INSTALLATION
In a secure installation, the waterproof antenna housing is
removed from the controller keypad and mounted outside of
a secured area. The control unit is installed inside the secured
area. The blank filler piece is then inserted into the controller
keypad in its place. This is appropriate for exterior doors
or “high-risk” locations.
To wire the EntryProx unit for a secure installation, refer to
Figures 5 and 6 and follow these instructions.
1. Touch a grounded object BEFORE touching the
main circuit board to guard against possible static
discharges.