User's Manual

ENTRYPROX – 4045-907 REV A
8
WIRING THE CONTROLLER KEYPAD FOR A
STANDARD INSTALLATION
In a standard installation, the antenna housing remains
installed in the controller keypad, and the complete unit is
installed outside of the secured area. This is appropriate for
interior doors or “low-risk” exterior installations.
To wire the EntryProx unit for a standard installation, refer
to Figure 4 and follow these instructions.
1. Touch a grounded object BEFORE touching the
main circuit board to guard against possible static
discharges.
2. Remove the main circuit board by pushing outward
on the two spring tabs in the direction shown in
Figure 4.
3. Lift the main circuit board.
4. Make the wiring connections for the door locking
devices, the power supply, and the alarm inputs and
outputs. Refer to the “Wiring EntryProx” section for
appropriate wiring diagrams.
5. Reattach the main circuit board to the controller
keypad unit.
6. Attach the controller keypad unit to the mounted
backplate and secure the EntryProx unit with a hex
screw or tamper screw.
For compliance with the UL294 Standard, additional installation
requirements must be met – see page 14.
Note: A ribbon cable holds the main circuit board to the
controller keypad board. DO NOT CUT OR REMOVE this
cable from its connector.