User's Manual

4900 Westside Avenue, North Bergen, New Jersey 07047
Tel: [201] 223-0050 Fax: [201] 223-0950
Hickory Industries, Inc.
N/5.5E Installation 8/5/97
Page 14 of 15
DO NOT TIGHTEN. This will ensure that you have
enough play to move the glass around without
bumping the glass.
Proceed with the remaining screws (use hi heat Loc-
tite). Make sure that the glass is sandwiched be-
tween silicone washer and the silicone spacer.
Slightly turn each screw until snug. It should be snug
but loose enough to move . Adjust the glass so that
the spacing is even around the sides and bottom of
the machine. You can now verify the glass spacing
with the side and the bottom of the machine.
Improperly Spaced
Properly Spaced
Column 4Column 3
Replacing the front glass
Insert the screw on to the glass (use hi heat Loc-tite).
As a hint, start with the middle screw it will give you
some leverage with the glass.
Slowly turn the screw onto the glass bar - DO NOT
TIGHTEN. Make sure that you do not see any
threads or that the glass rests on the threads.
Make sure that when resting the glass on the
screws, it only rests on the un-threaded portion
of the screw (closest to the head of the screw).
Before moving glass make sure threads are inserted
onto metal spacer
Threads Exposed
Note:
Uneven
Spacing
Note:
Even
Spacing
Silicone
Washer
Silicone
Spacer