User's Manual

Angle setting

VA:

Res.:

HA:

H Beep:

▲

Zenith

1″

2) After set one parameter ,press [ENT] or [▼] to move

the cursor down and you can also press [▲] to move

the cursor up;

3) Pressing [◄] or [►] can change the potion of option

box;

4) After complete to set the last one, press [ENT] to save

the settings and return to the previous interface.

5) HA: horizontal angle, there are two options “HR” and

“HL”;

6) VA: Vertical angle, you can select “Zenith”, “HA 0”,

“Elev”, “Slope”;

7) Res.:Angular Precision. You can select “1″”，“5″” or

“10″” when the unit of angle is “DMS”; You can

select “0.0002gon”，“0.001gon″” or “0.002gon” when

the unit of angle is “gon”;and You can select

“0.005mil”，“0.02mil″” or “0.005mil” when the unit

of angle is “mil”;

8) H beep: you can select “ON” or “OFF”.

11.2.2 Distance setting

1) In the setting menu, you can press [2] or press [ENT]

after moving the cursor to “Distance” to enter the

interface of “Dist. setting”，as shown in picture below: