User's Manual

measuring, enter the interface as shown in picture

(3);

[Notice*] p1-p2: The measured horizontal

distance from point 1 to point 2.

P2-TGT: The horizontal distance from point 2

to target point.

4) After input the offset distance from measured point 2

to target point, enter the interface of recording data.

[Notice*] if the direction “P1->P2” and

“p2->TGT” is same, the value is positive or

negative;

5) Press [ESC] to return to the previous interface;

9.4 Horizontal distance offset Mode

This function is to calculate the angle, distance , coordinate

of target point just inputting the horizontal after angle

measurement. But it is just suitable for the near point

measurement.

Target point

1) In the offset menu, press [4] or press [ENT] after

moving the cursor to “Offset/HD” to enter the interface

of “Offset/HD”, as shown below;