User's Manual

68
*[ENT] record
Offset/Angle->Result1/2
HR:
VZ:
SD:
*[HOT] to set T.H
Offset/Angle->Meas P
MSR1
MSR2
[MSR]
HR:
VZ:
SD:
ESC DSP
ENT
*[ENT] record
Offset/Angle->Result2/2
ESC
DSP
ENT
[ESC]
（1）
Z:
N:
E:
（2）
[DSP]
[DSP]
m
m
m
m
35°34′17″
69°42′11″
209.456
m
37°22′45″
70°33′26″
205.577
409.286
16.678
213.443
2) Pressing [▪] can enter the interface to change the target
height;
3) Aim at the measured point and press [MSR1] or
[MSR2] to start measuring. When finish the measuring,
enter the interface as shown in picture (2);
4) Aim at the target point, the data of angle, distance and
coordinate will be refreshed in time;
5) Pressing [DSP] can switch to check offset result data of
two pages;
6) Press [ENT] to enter the interface of recording the data.
7) Press [ESC] to return to the interface of
“Offset/Angle->Meas P”.
9.3 Double-Distance Offset Mode
It is specifically useful when the measured point is exactly
on the line of the two measurable points, as well as the distance
between measured point and the two measuring point is known.