User's Manual

66
interface of “Offset/Dist ->Meas Pt”，as shown in
picture (1);
L/R:
F/B:
U/D:
*R/F/U：+
（2）
Offset/Dist->Input
HR:
VZ:
SD:
*[HOT] to set T.H
Offset/Dist->Meas Pt
MSR1
MSR2
[MSR]
[ESC]
m
m
m
*L/B/D：-
m
35°34′17″
69°42′11″
213.983
（1）
1
2) If you want to change the target height, press the key
[▪];
3) Aim at the measured point and press [MSR1] or
[MSR2] to start measuring. After a successful
measurement, ether the interface, as shown in picture
(2);
4) In the interface as shown in picture (2), you can press
the key [ESC] back the interface as shown in picture
(1);
5) In the interface as shown in picture (2), input the value
of the offset which the target point deviates from
measured point. In the “U/D” input box, press [ENT]
to enter the interface of saving point, and this interface
displays the data of angle, distance and coordinate;
[Notice *]
*R/F/U: Right/front/up and these input values are
positive
*L/B/D: Left/behind/down and these input values are
negative
6) Input the coordinates of the point and press
[ENT] .After saved the data, return back to the offset
menu;