User's Manual

62
vertical plan baseline and coordinates of this point.
◆
◆
◆
{
◆
P3(X3,Y3,Z3)
P1(X1,Y1,Z1)
P2
(X2,Y2,Z2)
{
Length
Vertical
interval
Station
Target
（X,Y,Z）
1) Press the key [7] directly or press [ENT] after moving the
cursor to “Bevel->Input pt.，as shown in picture (1)”;
Pt.1:
Bevel->Input pt.
MEAS
KNOWN
（1）
Pt.3:
POINT1
POINT3
ENT
A
Z:
Bevel ->Result 1/2
Length:
VD:
HR:
*[ENT] record
VZ:
Bevel ->Result 2/2
N:
E:
Z:
*[ENT] record
[DSP]
（page-1）
（page-2）
[DSP]
（2）
[ENT][ESC]
m
m
m
m
m
12.104
49.634
31°15′56″
68°13′34″
43.246
76.996
215.402
Pt.2:
POINT2
2) Input three points for defining the slop plane. After
retrieving or measuring the coordinates of these three points,
press [ENT] to enter the enter the interface of the
“Bevel->result” ;
3) Turn the instrument to aim at the measured point, then the
data about the offset,vertical interval and coordinates will be