User's Manual

61
Pt.1:
Vert. Plane->Input
MEAS
KNOWN
（1）
Pt.2:
POINT1
POINT2
ENT
A
Z:
Vert. Plane->Result1/2
Length:
VD:
HR:
* [ENT] record
VZ:
Vert. Plane->Result 2/2
N:
E:
Z:
* [ENT] record
[DSP]
（page-1）
（page-2）
[DSP]
（2）
[ENT][ESC]
m
m
m
m
m
125.607
99.872
97°55′16″
56°13′44″
123.226
16.786
213.442
2) Input the two points for defining the vertical plane, and
after retrieving or measuring the coordinates of the two
points, press [ENT] to enter the interface of “Vert.
Plane->Result”;
3) Turn the instrument to aim at measured point in the
interface of “Vert. Plane->Result”，and the measured
data about “Length”, “VD” and coordinates will be
calculated automatically;
4) Pressing the key [DSP] to switch to check the result
data on the two pages;
5) Press [ENT] to enter the interface of “Rec. data”, and
you can record the measured data;
6) Press [ESC] to return to the interface of “Vert. Plane
->Input”.
8.6 Bevel
This function is used to measure the offset and vertical
interval from any point of slop plane to the start point P1 of the