User's Manual

60
5) If you want to refresh the target height, press the key
[ENT];
6) Repeat step (3) to continue measuring;
7) Press the key [ESC] to return to the program menu.
8.5 Vertical plane measurement
This function is used to measure the offset and height
difference from any point of vertical plane to the start point of
the vertical plan baseline and coordinates of this point.
Point 1
Point 2
Aiming
point
Length
Vertical
interval
Baseline
1) In the program menu,press the key [6] directly or [ENT]
after move the cursor to “Vert. plane” ,and enter the
interface of “Vert. Plane ->Input”,as shown in picture
(1) below: