User's Manual

59
VD
Prism height
prism
P
Target point
C
1) Press the key [5] or [ENT] after move the cursor to
“REM”, which as in picture (1);
REM
T.H:
Elv.:
*Input T.H
1.034
REM
T.H:
Elv.:
*Aim and meas.
MSR1
MSR2
【ENT】【ESC】
REM
T.H:
Elv.:
*[ENT] to update HT
[MSR]
m
m
m
m
m
m
【ESC】
1.034 1.034
1.034
(1)
(3)(2)
1
2) Input target height (the height difference from prism P
to target point C)in the “T.H” input box, and then press
[ENT] to enter the interface as shown in picture (2);
3) Aim at prism Pand press [MSR1] or [MSR2] to start
measuring. After a successful measurement, enter the
interface as shown in picture (3);
4) Turn the telescope to aim at measured point, at the
same time the height value will be refreshed in real
time until the height value of target height;