User's Manual

56
2) Retrieve or press [MEAS] to measuring the “Pt.1”;
3) Input the two angle of contingence “AZ.1” “Radius”
and “ArcL.”,then press [ENT] to enter the interface of
“ARC->Data” and display the arc data ,see the chapter
8.2.2;
4) Press [ESC] to return to the arc measurement menu.
8.2.2 Arc measurement
Enter the interface of “ARC->Data” after defining the arc,
as shown below:
ARC->Result 1/3
MSR1
DSP
MSR2
Length:
Offset:
HV:
*[ENT] record
ARC->Result 2/3
MSR1
DSPMSR2
N:
E:
Z:
*[HOT] to set T.H
ARC->Result 3/3
MSR1
DSP
MSR2
VZ:
HR:
SD:
*[ENT] record
[DSP]
[DSP]
[DSP]
（2）
ARC->Data
ESC ENT
Radius:
ArcL.:
AZ.2:
197.3431 m
301.9028 m
7°56′32″
（1）
[ENT] [ESC]
1) In the interface of “ARC->Data”,press [ENT] to enter
the interface of “ARC->Result ”,as shown in picture
(2);