User's Manual

46
7.4 S-O line pt.
This function is to stake out after calculate the data of
length, offset, height difference between stakeout point and
baseline point.
Press the key [4] or select the option “S-O line pt.” and
press the key [ENT] to enter the interface of “S-O line pt
->base”, as shown in picture (1).
[ENT]
[ESC]
（1）
MEAS
ENTKNOWN
S-O line pt ->base
Pt.1:
Pt.2:
1
（2）
Input
m
Offset:
Length:
HV:
m
1
m
1) After retrieve point 1 by reference to chapter 4.8 ,
refresh the display of “Pt.1” at the same time move the
cursor to “Pt.2” input box.
2) Pressing [MEAS] can perform the field measurement
of baseline points. See the chapter 4.9;
3) The way of the operation of point 2 is the same as it of
point 1.After finish retrieving, press [ENT] to enter the
interface of “Input”, which as shown in the picture
(2) ;
4) Input the length value in the “Length” input box;
5) Input the offset value in the “Offset” input box;
6) Input the height difference value in the “HV” input
box and enter the interface of “S-O-> Result”and see
the operation of chapter 7.6.
[Notice *]:
Length: the horizontal distance between baseline point
and target point .The value of length along point
1 to point 2 is positive, otherwise, negative.