User's Manual

45
7.3 S-O equidist.
Equidistance stakeout is to stake out the quarters which the
distance between the baseline points is divided.
Press the key [3] or press [ENT] after selecting “S-O
equidist” and to enter the interface of “Equidist.->base” ,which
as shown below:
（1）
[ENT]
[ESC]
MEAS
ENTKNOWN
Equidist.->base
Pt.1:
Pt.2:
+ ENT-
Input pile No.
2
Stakes:
Pile:
1
1
1
（2）
1) Retrieve the point 1 by the reference to the operation
of chapter 4.8;
2) Pressing [MEAS] can perform the field measurement
of baseline points. See the chapter 4.9;
3) The way of the operation of point 2 is the same as it of
point 1.After finish retrieving, press [ENT] to enter the
interface of “Input pile No.”,which as shown in the
picture (2) ;
4) The default number of “Stakes” is 2, and the “Pile ” is
1. You can input the total number of stakes in the
“Stakes” input box. Because the stake contains the two
baseline points, the minimum number is 2;
5) Pressing [+] or [-] can increase or decrease the number
of stakes .The maximum value is two times of stakes
number;
6) Press [ENT] to enter the interface of “S-O
->Result ”.See the chapter 7.6.