User's Manual

some points whose name contains “5”, which are

displayed in the list(as shown below).Then, move the

cursor to the wanted point and press [ENT],and it will

display the coordinate of the wanted point and back to

the previous interface;

Pt.1:

Project->base

MEAS

KNOWN

Pt.2:

ENT

Pt. list

12356

12357

▲

4) If the point input isn’t exit, you can enter the input

interface (as shown below).after the input, it save the

input data to the retrieved file, and then come back;

Input coord.

Pt.N:

Code:

code

5) If you don’t input point name, then you will enter the

coordinate input interface (as shown below), and it

will not save the data, and come back directly;

●Retrieve known points

The operation of retrieving known point is same as it of retrieve

data files, but the differences are as below;

1) The data of coordinate point is retrieved in the known

files

2) Input the point name and press the key [ENT];

3) If the point doesn’t exit, it will tip you that “No data

match”, and it doesn’t support direct input.

4) The point name can’t be null.