User's Manual

107
Define(H)-Spiral
Radius:
ENT
Length:
1
SAVE
ADD
DEL.
VIEW
01ST : 0.000
02STR : 0.000
03TRNS : 200.000
04ARC : 500.000
05TRNS : 950.000
6) After input the data, press [ENT] or [ESC] to return to
horizontal alignment list interface, as shown above
(right). The left side of list is line type, and the right
side of the list is mileage. The radius is of the end
point;
7) Press [ADD] to enter the interface of “Define (H)” ,
you can continue to add data;
8) Press [DEL.] to delete the selected data (the start point
can’t be deleted). If press [ESC], return back directly.
9) Press [SAVE] to save the data to the current road file;
10) Press [VIEW] to view the selected data, as shown
below. Here ,as an example of “circle”;
Edit-Circle
Radius:
300.000
400.000
Length:
1
EDIT UP
DOWN
① Press [UP] , then display the previous data;
② Press [DOWN], then display the next data;
③ Press [EDIT] to enter the interface of editing the
selected data, the interface and operation is same
as the input data;
④ Press [ESC] to return to the data list.
11) Press [ESC] to save the edit data, then return to road
menu.