User's Manual

106
interface of the input of intersection method, seen the
chapter 12.2.2. If press the other keys, you can enter
the input of data input;
Define(H)
Pile:
AZ:
STR
TRNS
ARC
PT
0.000
0°00′00″
Define(H)-Begin
Pile:
N:
ENT
E:
1
[Notice*] Pile: the mileage of the end point of the
current road line.
AZ: the azimuth of the end point of the
current road line.
2) In the case of no road data, press [STR] to enter the
interface of “Define(H)-Begin” ,as shown in
above(right) .After input, press [ENT] to enter the
interface of “Define(H)”;
3) Press [STR] to enter the interface of “Define(H)
-Line” ,as shown below(Left). After input, enter the
interface of “Define (H)”;
Define(H)-Line
AZ:
ENT
Length:
1
Define(H)-Circle
Radius:
ENT
Length:
1
4) Press [ARC] to enter the interface of “Define
(H)-Circle”,as shown above(right). After input, press
[ENT] to enter the interface “Define(H)”;
5) Press [TRNS] to enter the interface of “Define
(H)-Spiral”,as shown above(left). After input, press
[ENT] to enter the interface “Define(H)”;