User's Manual

102
Adjust the screw C to aim at the target precisely and press
[ENT] to confirm after a stable readout appears;
6) Set the vertical angle as V1+3′with the help of the vertical
tangent screw. Adjust the screw C to aim at the target
precisely and press [ENT] to confirm after a stable readout
appears;
7) After completed the operations, the result will be displayed,
as shown in picture below, you can press [ENT] to save the
result and return to “Calibrate” menu.
HA:
VA:
Tilt:
正镜下倾3分
ENT
225°00’00”
227°01’22”
-240
Zero: 3 Save？
ESC ENT
X CO: -0.7989
Adjust TiltX
Info
Notes: “ X CO” (linear coefficient) must be less than 1.5;
“Zero” (zero position) is normally between -20 and
+20, otherwise the compensator (tilt) must be
adjusted mechanically.
11.7 Date/Time
There is an independent timer-modul, even though you pull
out the battery, it also runs. You can calibrate the time with this
function.
1) In the menu interface, press [7] or press [ENT] after moving
the cursor to “Date/Time” to enter the interface of “Date &
Time”, as shown in picture below, the time displayed in the
interface is the time at the moment;