User Manual

Chapter 8 System Parameters and Comm ands
Hi-G-Tek Ltd. Micro electronics & Asset Tracking Technology - 177 -
Constant in
HGTSe alLongStatusBitEnum
HGTStatusAlertBurstMode (800h)
Remarks
If this flag is on, the DataSeal will send an Alert Burst message when the
Sealing Wire becomes opened. The Burst message that is sent in this case is
the Ale rt Bu rs t message or the Extended Alert Burst message.
This flag also det ermines whet her ot her t ypes of Burst message is allowed.
If this flag is off, the DataSeal won't send any kind of Burst message.
This flag can be set using the Start Alert Burst Mode and Start Alert
Burst Mode for All Seals, and cleared using the Stop Alert Burst Mode
and Stop Alert Burst Mode for All Seals commands.
Buffer Full
Seal Object Property BufferFull
Mne moni c BF
Description
This flag is set if a Re a d Da ta , Re a d
Eve n ts or Re ad Pa rame te rs co mm an d
requests too much data that exceeds the
size of the DataSeal's output buffer.
Constant in
HGTSe alLongStatusBitEnum
HGTStatusAlertBurstMode (8 0h)
Remarks
The largest block you can read is Maximal Me ssage Size – 13 (=67 byt es).
You can clear this flag using the Set/Reset Status command.
Scroll
Seal O bject Property Scroll