User Manual

Chapter 8 System Parameters and Comm ands
- 176 - Hi-G-Tek Ltd. Micro electro nic s & A sset Tra cking Techno logy
Remarks
One reason for this flag to be set can be in case you're using a DataReader
an d a COM DLL with a v ersio n s th at ar e n ewer t h at t h e v ersio n of t h e
DataSeal, and you're trying to execute a new command that the DataSeal
does not recognize.
You can clear this flag using the Set/Reset Status command.
Close Burst Mode
Seal O bject Property CloseBurstMode
Mne moni c BMC
Description
Determines whether the DataSeal will
send a Burst message when the Sealing
Wire becomes closed.
Constant in
HGTSe alLongStatusBitEnum
HGTStatusCloseBurstMode (1000h)
Remarks
The Burst message that is sent in this case is the Close Burst message.
You can set or clear this flag using the Set/Reset Status command.
Note
: This flag is in effect only if the Ale rt Bu rs t Mode flag is also set.
(Alert) Burst Mode
Seal Object Property AlertBurstMode
Mne moni c BMU
Description
Determines whether the DataSeal will
send Burst messages.