User Manual

Chapter 7 Evaluation Software
- 118 - Hi-G-Tek Ltd. Micro electro nic s & A sset Tra cking Techno logy
7.6.14 Start Alert Burst Mode
The Start Alert Burst Mode command puts the DataSeal into Alert Burst
mode. In this mode, whenever the DataSeal is opened, it transmits a
message that the DataReaders can receive to report the event.
The number of transmissions, the pause between then, and the data that will
be sent with it can be configured using some DataSeal Parameters. See
chapter 8 for a detailed descriptions of the DataSeal Parameters.
This command is multi-addressed, and can be sent to up to 8 DataSeals in a
single command. You must enter between 1 and 8 Seal IDs in the
Seals/Tags ID box, one in each line, before executing the command.
Figure 7-0