User's Manual

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
198
7
Evaluation Software
7.8.7.8. Write Data
The WRITE DATA command allows the User to write text in the entire
data area. This command can only work with one seal at a time.
There are two separate storage areas in each seal, ranging from
address 00 to address 53. The first area, from address 00 to 53, is
used to store data used by the DataTerminal. The data-range can
also be used by the HF system (reading and writing). Data stored
in address 54 to 2K is defined as a free high frequency area.
Maximum block size for a single session is 67 bytes.
In the event of a FAIL status response, the message type response
is "E8".
P#PK
Base
Address
Data
Block
Read Data command
can only work with one
seal ID
Number
of bytes
Msgt
Seal ID
Short
Status