User's Manual

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology

194

7.8.7.4. SET

The SET command is used to arm or set one or several seals.

Up to eight seals can be set in a single session. The SET

command cannot be activated if the Seal Wire is not

connected to the seal

Initiation of the SET command deletes all events stored in the

EVENTS MEMORY. An additional explanation of this feature

can be found in the Hi-G-TEK DataTerminal user manual.

Seal status will be indicated as closed (OK) or open (FAIL). An

example of this can be seen in the RESPONSE window of the

illustration below: The first row indicates an open seal and

TAMPER status, and therefore a FAIL result, while the second

row indicates a closed seal, status OK.

Evaluation Software