User's Manual

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology

180

7.7.2.5 Multiple Sessions

Multiple Sessions mode differs from

Single Sessions mode in that the

User can define the number of

cycles of interrogation (up to infinite).

The User can also define the

waiting period between each

session.

The cyclical interogation can be

stopped at any time by clicking on

the Stop Cycle button. Results of the

interrogation appear in a table

to the left of the button (See

section 4.2.6.)

Number of Cycles: Clicking on the

Broadcast Verify Cyclical

Interrogation button when there is a positive number in the Number

of Cycles window box will cause the system to perform that number

of sessions. When Number of Cycles is defined as -1, clicking on

the Cyclical Interrogation button will cause the system to perform

an unlimited number of sessions.

System Pause: This option allows the User to define a pause

between reader sessions.

Loop Through All Readers: When this option is selected, the

System Pause acts as a delay between the various readers.

NOTE: When the Loop Through All Readers option is selected, the

value in the No. of Cycles window box must be greater than the

number of readers defined.

Session # and Reset: The Session # window box shows the

sequential number of the next session. Clicking on the Reset

button resets this counter.

Evaluation Software