User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
Hi-G-DataReader Operation
Three LED light indicators are located
on the left-hand side of the electronics
compartment.
Power: The DataReader is activated by connecting it to a power
supply. At power ON and self-test the power indicator alternates
between the GREEN and RED indicators for several seconds.
If the check result is OK, the indicator remains GREEN. If a
problem was detected, the indicator remains RED.
When performing firmware download:
- MCU download, the indicator alternates between GREEN
and RED
- AVR- the indicator remains off
Channel 2 SD/RD:
When the indicator is red, the unit is in SD (sending data) mode.
When the indicator is green, the unit is in RD (receiving data) mode.
When the indicator is off, it is in stand-by mode.
Channel 1 SD/RD:
This channel is optional. The indicators operate in an identical
manner to those for channel 2:
When the indicator is red, the unit is in SD (sending data) mode.
When the indicator is green, the unit is in RD (receiving data) mode.
DataReader Operation Instructions
4
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
48