User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
- Page 49
- Page 50
- Page 51
- Page 52
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
153
6
RS 485/232 Communication Protocol
6.5.5.4. Get Status.
6.5.5.5. Get Burst Message
6.5.5.4.1. Command Transmission
6.5.5.4.2. Get Status Command Response
This command is to retrieve the READER status.
Reader > LSC
STX #B R# CMND(0016h) CRC ETX
1 2 2 2 2 1 # of bytes
The following string is the general response.
Reader > LSC
Reader > LSC
STX #B R# MSGT(xx16h) R_status CRC ETX
1 2 2 2 4 2 1 # of bytes
6.5.5.5.1. Command Transmission
This command is used to retrieve the alert messages transmitted
asynchronously by seals that are in alert burst mode.
STX #B R# CMND(0 01 Ch) Channel CRC ETX
1 2 2 2 1 2 1 # of bytes
Channel indicates the source channel for the results. The value is
according to the table in paragraph 5.5.2.1.