User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
- Page 49
- Page 50
- Page 51
- Page 52
- Page 53
- Page 54
- Page 55
- Page 56
- Page 57
- Page 58
- Page 59
- Page 60
- Page 61
- Page 62
- Page 63
- Page 64
- Page 65
- Page 66
- Page 67
- Page 68
- Page 69
- Page 70
- Page 71
- Page 72
- Page 73
- Page 74
- Page 75
- Page 76
- Page 77
- Page 78
- Page 79
3.9.1.2.
> view by id
After entering the seal ID and pressing OK, the
seal ID screen is on. If an incorrect seal ID has
been entered, the following appears on the screen:
This function allows the user to type in a specific
seal ID. The seal's events are then displayed
on the screen.
3
view by id
enter seal id
--------------------------------
id: ______________
does not exist
press enter
press ok to continue
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
35
DataTerminal - Operating Instructions
Information is obtained in the same manner when
choosing the > view by id option except for the
initial procedure for reaching the desired seal.