User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
- Page 49
- Page 50
- Page 51
- Page 52
- Page 53
- Page 54
- Page 55
- Page 56
- Page 57
- Page 58
- Page 59
- Page 60
- Page 61
- Page 62
- Page 63
- Page 64
- Page 65
- Page 66
- Page 67
- Page 68
- Page 69
- Page 70
- Page 71
- Page 72
- Page 73
- Page 74
- Page 75
- Page 76
- Page 77
- Page 78
- Page 79
3
The Alphanumeric keyboard, situated in the
center and at the bottom of the keypad panel,
is used for entering alphanumeric data.
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
Note: Ensure the seal you are reading is at least 60 cm. (2 ft.) from
any other seal in the vicinity.
23
DataTerminal - Operating Instructions
SET
The SET key is located on the right hand side of
the panel, below the arrow keys. To begin a SET
sequence, press the SET key. The seal must be
closed before performing the SET sequence. If
the seal is open, a warning message appears
on the screen. .
A SET sequence may be entered with or without
cargo manifest information. When the SET key
is pressed, the following screen appears:
3.5. Set Procedure
CID...................
Cont................
Dest................
Point dataterminal at seal
press ok to confirm
3.5.1. Basic Set Procedure