User's Manual

2
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
DataSeal Installation
18
Step 4: Setting the Seal using the DataTerminal
Press the ON key and verify that the green light is on. Place the
DataTerminal between 5 and 40cm from the seal and press the
SET key.
Step 5: Reading the Seal with the DataTerminal
procedure This is carried out at
destination.
Place the DataTerminal between 5 and 40cm from the Seal and press
the READ key. The appearance of the OK notation on the units display
screen and two beeps indicate that everything is in order and no
mishaps have occurred during transport. The TAMPERED notation,
appearing together with a single audible beep indicates that
the seal was tampered with during transport.