User's Manual

The Micro Reader communicates with the DataSeal or the DataSeal-125
over the low frequency channel using 125KHz as the carrier.
The Micro Reader is used for executing one or two functions, depending
on the model:
Micro Reader with READ only - Model: IG-MA-125
This device is used for checking the seal status.
Approach the DataSeal as shown in Fig.2
to a distance of 3-8cm and press the R button.
(Item 1 in Fig.1)
In the event that the seal status is OK the LED
(item 2 in Fig.1) will turn Green, and a
corresponding “click” will sound.
In the event that seal status is TAMPERED,
the LED will turn Red and a corresponding
“beep” will sound.
In the event that the communication between
the Micro Reader and the DataSeal failed,
the Micro Reader will pause for two seconds
and the LED will flash Red three times with
corresponding three fast “clicks”.
2
Micro Reader
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
Micro Reader with SET option - Model: IG-MA-125S
All instructions for checking the seal status are
the same in both models. This model can also
perform a “Soft Set”: setting the seal (OK status)
without erasing the events logged in seal’s
memory.
To perform a “Soft Set”, approach the seal as
shown in Fig.2, and press the S button (item 1
in Fig.3). In the event of successful “Soft Set”,
the LED will turn Green and a corresponding
“click” will sound.
In the event that the “Soft Set” command failed,
the Micro Reader will pause for two seconds, and
then the LED will flash Red three times with
corresponding three fast “clicks”.
3
Micro Reader
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
Fig. 1
21
1
Fig. 3
D
a
t
a
S
ea
l
D
a
t
a
S
ea
l
Fig. 2