User's Manual

Setup and Analysis
Overview
Tanker Truck Monitoring System- User’s Guide 43
Figure 4-4. Events Tab
2. Click the MIP Start button. A list of allocated seals, identified by the Reader, is shown.
3. Click Interrogation button to execute command and verify that all ‘attach’ commands are
OK.
NOTE: If there is no response, perform another interrogation.
4. Click Get Application Status and view response prompt – GPS OK, battery, etc.
4.1.6 Configuring Site Coordinates
The coordinates of the various locations that the Tanker Truck is to pass must be defined….
1. Click the Sites tab. The following window appears.