User's Manual

Initial System Setup
Defining the Truck Configuration
Tanker Truck Monitoring System- User’s Guide 24
2. In the general area, define the following fields:
• Truck ID - enter the truck identification. This is usually the
license plate.
• LCU – enter the ID on the LCU label (i.e 365 as illustrated below)
Figure 2-3. Example of LCU Identification Label
• Tanks – check the tanks associated with the current truck (1/2). This will enable either
one or both configuration areas.
3. Configure the seal IDs according to their location, for Tank-1 and Tank-2 (if relevant):
• Verify that the Active box is check for every valve and hatch where a seal is installed.
• Verify that the Autoread option is checked. This causes the Reader to periodically read
the seal IDs and update the data
NOTE: To read once, disable Autoread and click the Read button. To Clear all the data, click
Clear.
The following figure shows the General (Truck ID, LCU, etc.) and Tank-1 option. (The
options for Tank-2 are identical to those of Tank-1.)
Figure 2-4. Partial Tab Showing Tank-1 and Editing Options
NOTE: The Seal Status Indicator serial number and version are updated automatically upon enabling
Autoread or clicking Read.
e.
g
. of LCU ID
Check to interro
g
ate
seals automatically
Active hatch seals
Active valve seals
Seal Status Indicator
if ti