User's Manual

Initial System Setup
Defining the Truck Configuration
Tanker Truck Monitoring System- User’s Guide 22
e dialog includes the following tabs:
Tab Description
General
Parameters
CC1020
HF RF Commands
Memory
EEPROM
Truck Configuration Required for configuration.
Used to configure system elements for a specific truck. See section
2.6
Sites
Application
Parameters
Events
Firmware Download
Display Boxes
2.6 Defining the Truck Configuration
This tab is used to configure the system elements for a specific tank truck. This includes the
following:
• Number of tanks supported by the truck - one or two tanks
• ID of the seals to be installed on each tank – according to their compartment and location
• ID of the AVL Reader and AVL Units
• Seal Status Indicator
• Additional information
This procedure enables the elements to communicate with each other and allows identification at
the Control Center.
This tab is also used to update the configuration when changes are made in the system. For
example, seals are removed or replaced, tanks are added or removed (to trucks where this is
relevant), etc.