User's Manual

Fleet Application User’s Guide 15
2
I
I
n
n
i
i
t
t
i
i
a
a
l
l
S
S
y
y
s
s
t
t
e
e
m
m
S
S
e
e
t
t
u
u
p
p
2.1 General
The first phase in the installation consists of verifying that the system elements are operational
and performing site configuration procedures such as configuring the system topology, defining
authorized refinery zones, etc. The Setup procedure is performed using the Configuration Tool
software application.
NOTE: It is recommended to perform the setup phase at the Hi-G-Tek distributor site or office.
If the zone definitions (coordinates and area) of the refineries are not available, they may be
physically mapped at each refinery according to the instructions in section 2.7.
This chapter provides step-by-step instructions on all the operations required at the initial phase.
It includes:
• Interconnecting the TTSM System elements;
• Connecting and launching the Configuration tool;
• Performing the basic setup and configuration procedures;