User Manual

Designed and Engineered in the UK by HH Electronics LTD.

HH VRE cabs can be mounted on the floor, or a suitable pole or

tripod. Don't over-extend poles/tripods; ensure at least 4 x the pole

diameter is still inside the outer pole. Make sure the legs have a good

splay on tripods, but do not obstruct doorways or other access-ways.

BASIC SETUP

Similarly, when turning off your system always turn down the level controls on your power amplifier and then turn off its power

before turning off other equipment.

6) Cables- never use a shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the

amplifier load and could cause damage to your complete system.

In order to take full advantage of it and enjoy long and trouble-free performance, please read this owner's manual carefully, and

keep it in a safe place for future reference.

2) Retain these instructions

4) Unpacking: Please retain the packing carton and liners in case the unit should need to be returned at any time.

With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFORE turning on

your power amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.

7) Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with

placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage.

9) Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.

The Vector series are professional specification cabinets designed to give exceptional dynamics, clarity and projection in all

applications such as a portable PA.

1) Read Instructions carefully before installing or operating this product.

Thank you for purchasing a HH Vector Passive Full Range Enclosure.

3) Comply with warnings: All warnings and instructions for these products should be adhered to.

By turning on your power amplifier LAST and making sure its level control are set to minimum any transients from other equipment

will not reach your loudspeakers.

Wait until all system parts have stabilised. This can usually take a couple of seconds.

5) Amplifier connection. In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your

sound system.

(Stand not included)

35mm pole socket