Datasheet

Travelstar 80GN Hard Disk Drive Specification
63
10.0 Register
Table 37: Register Set
Logic conventions: A = signal asserted
N = signal not asserted
x = either A or N
Communication to or from the device is through an I/O Register that routes the input or output data to or from the
registers addressed by the signals from the host (CS0-, CS1-, DA2, DA1, DA0, DIOR- and DIOW).
The Command Block Registers are used for sending commands to the device or posting status from the device.
The Control Block Registers are used for device control and to post alternate status.
Addresses Functions
CS0- CS1- DA2 DA1 DA0 READ (DIOR-) WRITE (DIOW-)
N N x x x Data bus high impedence Not used
Control block registers
N A 0 x x Data bus high impedance Not used
N A 1 0 x Data bus high impedance Not used
N A 1 1 0 Alternate Status Device Control
N A 1 1 1 Device Address Not used
Command block registers
A N 0 0 0 Data Data
A N 0 0 1 Error Register Features
A N 0 1 0 Sector Count Sector Count
A N 0 1 1 LBA Low LBA Low
A N 0 1 1 LBA bits 0-7 LBA bits 0-7
A N 1 0 0 LBA Mid LBA Mid
A N 1 0 0 LBA bits 8-15 LBA bits 8-15
A N 1 0 1 LBA High LBA High
A N 1 0 1 LBA bits 16-23 LBA bits 16-23
A N 1 1 0 Device Device
A N 1 1 0 LBA bits 24-27 LBA bits 24-27
AN111Status Command
A A x x x Invalid address Invalid address