Datasheet

The head number of the last transferred sector. (L=0)
In LBA mode, this register contains current LBA bits 24 - 27. (L=1)
H
The cylinder number of the last transferred sector. (L=0)
In LBA mode, this register contains current LBA bits 8 - 15 (Low), 16 - 23
(High). (L=1)
Cylinder High/Low
The sector number of the last transferred sector. (L=0)
In LBA mode, this register contains current LBA bits 0 - 7. (L=1)
Sector Number
The number of requested sectors not verified. This will be zero, unless an
unrecoverable error occurs.
Sector Count
Input Parameters From The Device
13.5.17 Recalibrate (1Xh)
...See Below...Status----1000Command
--------Device/Head----D1-1Device/Head
--------Cylinder High--------Cylinder High
--------Cylinder Low--------Cylinder Low
--------Sector Number--------Sector Number
--------Sector Count--------Sector Count
...See Below...Error--------Feature
--------Data--------Data
01234567Register01234567Register
Command Block Input RegistersCommand Block Output Registers
V00-V0V00VV00000
ERRIDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCBBK
0123456701234567
Status RegisterError Register
Figure 92. Recalibrate Command (1Xh)
The Recalibrate command moves the read/write heads from anywhere on the disk to cylinder 0.
If the device cannot reach cylinder 0, T0N (Track 0 Not Found) will be set in the Error Register.
Hard disk drive specification for DSCM-11000/-10512/-10340
111