Operating Instructions

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
1.
Partially loosen the two set screws (X) in the yoke
at the top of the motor assembly (G) to allow for
installation of the downrod (A).
1
X
G
Yoke
2.
Remove the downrod pin (B) and downrod clip (C)
from the downrod (A). Insert downrod (A) -- or a
longer downrod, if purchased -- through canopy (D),
then feed the wire harness from the fan through the
downrod (A). Secure downrod (A) into the yoke of
motor assembly (G).
2
B
A
C
A
D
3.
Align the holes of downrod (A) and the yoke of motor
assembly (G), then re-install the downrod pin (B) and
downrod clip (C). Once secure, re-tighten the set
screws (X).
3
G
C
X
A
B
G
9