Operating Instructions

TROUBLESHOOTING
PROBLEM
The fan is noisy.
The fan operates
correctly, but the
lights are not
working.
POSSIBLE CAUSE
1. The blades are loose.
2. There is a cracked blade.
3. The outlet box is not secure.
4. The mounting bracket is not
secure.
1. The bulbs are not installed
correctly.
2. The light kit wire plugs are
not connected properly.
3. There is a faulty wire
connection.
CORRECTIVE ACTION
1.Check and tighten all screws that hold
the fan blades to the blade arms and the
motor.
2.Replace the cracked blade.
3.Ensure the outlet box is secured to the
building structure.
4.Ensure the mounting bracket is secured
to the outlet box and that the screws are
tight.
1. Re-install the bulb(s).
2. Ensure the single-pin connectors in the
light kit are connected properly.
3. Turn the power off and check all
connections at the ceiling outlet box.
1. LED indicator does not
illuminate when remote button
1.
Replace the remote battery with a new
Remote doesn’t
work.
is pushed.
2.The remote control is not
synced with the fan’s receiver.
12-volt battery.
2. Turn off the main power, then turn it back
on. Within 30 seconds, press and hold
the high and low speed buttons on the
remote at the same time for 5 seconds.
signaling a successful synchronization.
Once complete, the fan will start on the
low speed with the light (if applicable) off.
20