Installation Instructions

Heyday Mini Speaker

Included

• Heyday Mini Speaker

• Micro USB charging cable

Pairing

• Power ON speaker

• Rapid ﬂ ashing white light

• Use Bluetooth settings on your phone to pair with HEYDAY SPEAKER

• White light turns solid followed by a chime-pairing successful

Indicators

• Flashing Red - Low Battery

• Solid Red - Charging

• No Red Light - Fully Charged

• Flashing White Fast - Pairing Mode

• Flashing White Slowly - Bluetooth Connected

• Ascending Tones - Power on

• Descending Tones - Power off

• Three Rapid Tones - Ready to pair

• Single Chime - Paired

• Two Rapid Dings - Low Battery

• Quick Ascending Tone - Max Volume

• Quick Descending Tone - Min. Volume

Press - Volume Up

Hold - Next Track

Press - Volume Down

Hold - Last Track

Press - Play/Pause/

Answer/End Calls

Hold - On/Off/

Pairing/Reject

incoming call

Microphone

Charge Light Charge Port

Front Side

Bottom

model：TT1142

PAGE 1
model：TT1142 Heyday Mini Speaker Front Side Press - Volume Up Hold - Next Track Microphone Bottom Press - Play/Pause/ Answer/End Calls Hold - On/Off/ Pairing/Reject incoming call Charge Light Press - Volume Down Hold - Last Track Charge Port Included • • Heyday Mini Speaker Micro USB charging cable Pairing • • • • Power ON speaker Rapid flashing white light Use Bluetooth settings on your phone to pair with HEYDAY SPEAKER White light turns solid followed by a chime-pairing successful Indicators
PAGE 2
Charging • • • • Full charge requires approximately 2-3 hours Charging is complete when red light turns off Plug micro end of charging cable into the bottom of speaker DC 5V socket Plug USB end of charging cable into a DC 5V USB power supply Troubleshooting • • • • If the speaker is not working correctly, turn it on/off to reset If the speaker won’t turn on, recharge the battery and try again If the speaker won’t charge, make sure the supply works, is 5V >1A, and not damaged If the speaker makes no sound