Owner's manual

PIN
1
2
3
4
5
6
7
8
RS-232
TXD
RXD
RTS
CTS
DSR
SG
DTR
DCD
RS-485
D+
D-
GND
RS-422
RX+
TX+
RX-
TX-
FULL
GND
【Software installation and setting】
1 Set the IP address of the device
The IP address of the device and the PC must in the same subnet network
(the default IP address of the device is 192.168.1.233). First, must make the IP address of
the device in the same subnet network of PC.
If they are not in the same subnet network or the IP address have been used by another device,
Use Telnet change the IP address of the device
1 “Start”------“all programs”------“Running”
Input default IP address of the device “Telnet: 192.168.1.233”
2. Click “OK”, setting the IP of device by telnet. Choose the menu by ↑↓←→ of the