HXSP-1002 2 ports RS-232 or RS-485/422 serial device server user manual
【Summary】 HXSP-1002 is a serial device server which can contact with network fast. It provides one line RS-232/485/422 (RS-232: DB9M: RS-484/422 / 4 bits terminal block) and 1line 10Base-T, it can manage the disperse serial device or host computer by network, easily and convenience. Setting or software upgrade by serial program group in applying. Support TCP, UDP, ARP, ICM and DHCP protocol, support Windows Native COM and auto-contact function once the network intermit.
EIA RS-232, RS-485, RS-422 standard NO.of ports: 2 RS-232 or RS-485/RS-422 (RJ45) port optional RS-232 signal: TxD, RXD, RTS, CTS, DTR, DSR, DCD, GND RS-422 signal: Tx+, Tx-, Rx+, Rx-, GND RS-485 signal: Data+, Data-, GND Parity: None, Even, Odd, Space, Mark Data bit: 7bit, 8bit Stop bit: 1, 1.
【LED indicator】 Power supply input: ATC bright all along Serial 1 connected: Port1 on bright all along Serial 2 connected: Port2 on bright all along Connected network: LINK and TX/RX indicator bright all along 10/100Base-T Ethernet port The 10/100BaseT(X) ports located on facility front panel. The PIN define of RJ45 port display as follows, Connect by UTP or STP. The connect distance is no more than 100m. 100Mbps is used 100Ωof UTP 5, 10Mbps is used 100Ωof UTP 3, 4, 5.
RS-232 RS-485 RS-422 1 TXD D+ RX+ 2 RXD D- TX+ 3 RTS RX- 4 CTS TX- 5 DSR FULL 6 GND 7 DTR 8 DCD GND GND 【Software installation and setting】 1 Set the IP address of the device The IP address of the device and the PC must in the same subnet network (the default IP address of the device is 192.168.1.233). First, must make the IP address of the device in the same subnet network of PC.
2. Click “OK”, setting the IP of device by telnet. Choose the menu by ↑↓←→ of the keyboard and quit by “ESC” key. 3 Choose the “Server” menu and push “Enter” key, Change the IP of the device. 4 Change the IP (the changed IP must be in the same subnet of the PC). Push “Esc” key, quit the network setting.
6 Push “Enter” Key, save the setting. 2. Create the Virtual COM port on the PC Setup the “setup_nt_2K.exe” software, then you will find the “COM port over tcp/ip.exe” application in the control panel of windows OS. Running the “COM port over tcp/ip.exe” application and create virtual COM port communicate with the device on the PC.
virtual COM port as follows: 1 Input the IP of the device 2 Input the NO. of the port of the device(Inpu t 1~8) 3 Input 300 4 Default the parameter Click the “OK”, Click “Save”. COM5 has been created. Now, the COM5 can communicate port of the device. with the terminal on the NO.
Other Virtual COM port setting the sa me as COM5 Note: Pay attention to the questions as below: (1) Please make sure that the power adapter is 5VDC (2) When connect to PC, use cross-over cable.
【Application】 NP322 application sketch map: Working mode: 1. Based on Virtual COM port 2.
