Installation Manual

2. Take a Smart Antenna out of its box (item 2) and disassemble its

QL1212 Through hole mount module (plastic part). We

recommend keeping it as a spare part otherwise throw it away.

3. As next step unpack, QL1210 Magmount Module (item 3), take

the enclosed screws (3x M5x16), the spring lock washers (3x for

M5) and the washers (3x Ø5.3/10/1), put them into the foreseen

holes as displayed. Note the order of the fasteners. Then mount

the Magmount from underneath into the QC1000 Bottom Part with

1.2Nm torque.

Now you can put the Antenna (modified item 2) into the upper right recess with front (HxGN Logo

heading to front).

4. Unpack a RAM mount base plate diamond (item 7), a RAM mount arm (item 8) and a RAM mount

suction mount base (item 9) and stick it together.

5. Take a Display (item 5), attach the assembled RAM Mount bracket from step 5 with the screws and

spring lock washers which will be found in the Display Box.

Put the Display into the recess as displayed. The RAM mount arm and suction cup must be

orientated to the left.

6. The Battery Pack (item 10) is placed into the upper middle place holder as displayed.

7. Take all cables and put it into the big space to the left as displayed. The Vehicle Charger (item 11)

and the Charger for single Quick Mount Unit (item 12) can be placed into the middle of the cables.

8. Then put the QM1319 CAS 10 Visitor Unit Travel Adapter (item 13) on the upper place as displayed.

9. The manual (A5 format, item 14) must be placed into the foreseen holder (14)

!!! BE AWARE !!!

50kg magnetic force

Do not use different screw sizes than M5 x 12 and

don’t forget to put the spring lock washers between