Installation Manual

6.4 QD200 Remote Display

The QD200 Remote Display offers the following attributes:

• Indication of surrounding vehicles through 12 dual color LEDs (red/green) in a circle

• Status Indication through 4 dual color LEDs (red/green): Power, GPS, Reverse and Mode

• Multifunction push-button

• Piezoelectric buzzer

• Ambient light sensor

The maximum length of the display cable is 15m. This can be achieved be connecting several

display extension cables together.

The LED brightness is automatically controlled based on ambient light, in order to provide

dimming for night operation.

The buzzer, with a maximum volume of 85dB (at 10cm distance), can be automatically controlled

based on ambient noise.

The image shows a display while the device is operating in a

vehicle, traveling forward (‘Reverse LED’, second from top, is

OFF) and a vehicle (equipped with another Hexagon CAS

device) is detected. The LED on in the 12 o’clock position

indicates the presence of a vehicle in front. Several colors and

sounds indicate different threat levels. Depending on the

distance to other vehicles and on the configuration parameters

an alarm might be audible. The center compass displays

direction and distance of vehicles within the RF transmitter /

receiver range but it also serves to display error codes in the case a system failure was detected.

The LEDs on the left side of the display show the status of the system. They indicate if the device

has enough power, has acceptable GNSS reception or is traveling backwards as well as other

information about the system.

Depending on the configuration, pushing the square button on the right of the display can trigger

three functions:

1. Flag special events in the unit’s log-file: for example an incident or a situation where the

user believes the system didn’t perform as expected.

2. Acknowledge an alarm: The operator can stop the warning sound for example when being

towed by another vehicle.

3. Pressing the button for 3 seconds or longer seconds will restart the QC1000 Smart

Antenna.

All alarms are indicated during a minimum of 1.5 seconds to allow the operator to see and react

to it. The alarm will stop once the threat is gone or if one of the two vehicles stops.