Installation Manual

© Hexagon AB Commercial in Confidence 17
5.9 LTE
The LTE module acts as an alternative to the WiFi.
The module supports the following bands:
• LTE FDD: B1/B2/B3/B4/B5/B7/B8/B12/B13/B18/B19/B20/B25/B26/B28
• LTE TDD: B38/B39/B40/B41
With a maximal output power of 23±2 [dBm].
In case of using the 902-922 [MHz] band for ISM radio, the BAND-8 of the LTE module is
disabled due to overlapping of frequencies.
5.10 Connector Description
QC1000 features a M16-19p male connector compatible to cables:
• QM1105 Cable Smart Antenna 5m angled
• QM1106 Cable Smart Antenna 5m straight
• QM1107 Cable Smart Antenna 6m straight light
• QM1108 Cable Smart Antenna 6m straight Visitor
Pin
Name
Description
1
Batt +
Positive power-supply for the unit
2
CAN1-L
Low level CAN bus input/output line
→ for the communication with Radars / PA …
→ the same signal as on Pin 19
3
Serial-GND
Reference voltage for the serial communication RS232
4
GPIO-1
Digital Input and Output
Analog Input
5
ETH-RX+
Ethernet Receive / Transmit positive channel 2
6
ETH-TX+
Ethernet Transmit / Receive positive channel 1
7
GPIO-3
Digital Input and Output
8
GPIO-2
Digital Input and Output
9
CAN2-L
Low level CAN bus input/output line
→ dedicated CAN for VIS
10
GPIO-0
Digital Input and Output
Analog Input
11
GND
Negative power-supply for the unit
12
CAN1-H
High level CAN bus input/output line
→ for the communication with Radars / PA …
→ the same signal as on Pin 18
13
Serial-RX
Receive input for the serial communication RS232
14
Serial-TX
Transmit output input for the serial communication RS232
15
ETH-RX-
Ethernet Receive / Transmit negative channel 2
16
ETH-TX-
Ethernet Transmit / Receive negative channel 1