Maintenance and Service Guide

CAUTION: Before positioning the tablet with display panel facing down, make sure the work surface
is clear of tools, screws, and any other foreign objects. Failure to follow this caution can result in
damage to the display panel.
1. Remove the six Phillips PM1.4×3.0 screws (1) that secure the back cover to the
display panel assembly.
NOTE: The following screw should have a warranty tag (2) on it. This tag should not have any
signs of tampering on it. When repairs have been completed on the tablet, this warranty tag
should be replaced.
2. Remove the Phillips PM1.4×4.2 screw (3) that secures the back cover to the
display panel assembly.
CAUTION: Do not completely separate the back cover from the display panel assembly in the
next step. The display panel ribbon cable is connected between the display panel assembly and
the system board and can be damaged if too much separation is achieved.
3. Separate the bottom edge of the back cover from the display panel assembly and swing it (1) up
and away from the display panel assembly.
4. Remove the Phillips PM1.4×2.5 screw (2) that secures the battery cable bracket to the
display panel assembly.
5. Remove the battery cable bracket (3).
The battery cable bracket is available using spare part number 776000-001.
Back cover
17