Specifications

Details and SolutionDescriptionEvent code
Check the version of firmware used for the
upgrade. The firmware is incompatible with
this device.
SCSI: flash image does not fit bootcode44
The application software has locked media
removal and either the software or device
user interface attempted to remove the media.
NOTE:
This IS NOT a hardware issue.
If the issue cannot be resolved with the
application software, power off the device,
disconnect the data cable, and then power
on the device.
SCSI: media removal prevented by drive45
SCSI: media removal prevented by library46
Check the firmware file used for the upgrade.
The firmware is incompatible with this device.
SCSI: flash image does not fit personality47
The tape drive is not supported by the
firmware in this device. Upgrade the device
firmware to the most up-to-date version. Verify
that the drive has an HP MSL-G3 or 1/8 G2
firmware revision. If firmware is not the
correct type, the wrong tape drive has been
installed. Use only HP-approved support to
insure that the correct tape drives are used.
SCSI: tape drive not supported by this library48
Verify that a supported magazine for that slot
is inserted. If the magazine is in the lower left
position, verify that the type of magazine is
consistent with the mailslot configuration.
SCSI: incompatible magazine, magazine not
accessible
49
• Retry the operation.Source not ready4A
• Retry the operation.Destination not ready4B
The application software made an illegal
request.
Reservation failed4C
Retry the operation.
Library controller busy4D
Invalid robotic request4E
Robotic not initialized4F
• Verify that the drives are installed cor-
rectly.
• Verify that the cartridge and tape drive
generation are compatible. See “Back-
ward read compatibility” on page 47.
• Verify that the tape is correct for the oper-
ation initiated.
Incompatible medium51
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 149